QUALITY CONSTRUCTION


Dildo holders are connected to the rust proof action arm by the same brass bearings that are used inside the machine.
Jetaime has a patented dildo mounting assembly that makes it possible to easily mount many of the dildos and vibrators you already own. Diameters from 3/4 inches to 3 inches (2.36 to 9.42 inches around) have been tested. The dildo mounting assembly to mount dildos between 1-5/8 and 2 inches (5.10 to 6.28 inches around) is shipped with Jetaime. The smaller size for 3/4 to 1-3/8 inch (2.36 to 4.32 inches around) dildos, is shipped if requested. Measure your dildo by wraping a string around it just above the base. Then use a ruler to measure the string. Only the soft flexible types are recommended. Adapter rings are provided. Here are a few that will fit.



Moving the bearing between the four holes on the stainless steel arm changes the stroke length from 3 to 4 inches deep. Also moving the bearing raises or lowers the dildo 1/2 inch. This adjusts the holder to either tap your bottom or not touch at the top of each stroke.
Power is supplied by an industrial grade, gear reduction motor. This powerful motor is rated at 33 inch-lbs of torque, or about ten times what is needed for Jetaime. The power requirements are 115 volt 60 Hz Ac.
